Most INARCO products are supplied as high concentrates:
- lower storage costs
- long product stability
- dilution to ready-to-use cleaning solution on site, customized dilution depending on application
INARCO products are safe for work and the environment:
- low to no VOC, non-flammable
- no acids or alkalis
- pH-value around the neutral range (approx. 6-8)
- partly completely free of labeling
- all no dangerous goods (easy storage, uncomplicated transport, no problem with disposal)
Performance and efficiency of INARCO products = economy:
- cleaning solution is permanently reusable (use in a cycle)
- no redistillation (= costs) necessary
- no product losses due to evaporation (efficiency), long bath service life
INARCO products involve the whole cleaning process:
- does not leave an oily film after drying
- can be easily rinsed off with water if necessary, rinsing solution can be reused
- simple, cost-effective disposal - only the sediment is disposed of
Settling behavior of INARCO products:
Using the example of a metallic car paint |
After the cleaning process, the detached paints/lacquers/resins settle on the floor. Depending on the composition and dilution ratio, this takes 30min to 2h.
Only the sediment has to be disposed of in accordance with local regulations (usually incineration), which depends on the substances removed (paints/lacquers/resins). This means that only a small part of the cleaning solution is disposed of, and the rest can be used for further permanent work. If the performance of the cleaning solution decreases, only the corresponding INARCO product must be added to increase the performance again. |
Due to the settling behavior of the removed paints/inks/resins/adhesives, only max. 1/4 (usually less) have to be disposed of after the cleaning process, compared to the used solvent or alkaline product. The same principle applies to rinsing solutions: Rinsed-off product is returned to the cleaning cycle, remaining rinsing solution can be reused. Disposal costs can thus be drastically reduced! |